They have tamper-resistant tanks and compartments
assembled as integral units for flush mounting on a flat,
rigid surface, generally a concrete pad. The entire unit
may be rolled, skidded or jacked into place, or hoisted
by its lifting hooks. They are used to step down high
voltage distribution power supplied through underground
cable. The cables can be economically connected to the
bushings or to factory-installed auxiliary equipment with
a minimum of labor. The high voltage compartment door
on the left can be opened only after the low voltage door
on the right has been opened. that door has a padlockable
handle to its 3-point latch. The compartments are separated
by a metal barrier.
Optional Features:
Radial or Loop Feed. Live or Dead Front.
Load break switch 15 KV, 200A, on-off.
Load break switch 15 KV, 200A, 4 position(loop feed system)
Lightning arresters: Live or Dead Front. Bayonet Expulsion
Fusing. Bayonet with ELSP Current-Limiting Backup Fuse.
Dry well canister with Current-Limiting Fuse.
McGraw Edison NX Current-Limiting with ARC-Strangler Loadbreak
Device. De-energized Dual Voltage Switch.
Liquid Level Gage. Dial type Thermometer. Pressure Vacuum
Gage. Drain Valve with Sampling Device. Pressure Relief
Valve or Device. One piece HV Integral Bushings. HV Bushing
Insert, Single or Feedthru. Secondary LV Circuit Braker
or Panel Board. Whatthour Meter System Special Low Sound
Level. Improved Higher than Standard BIL. Pentahead Bolt
Latching System. Mechanical Interlock Switch-Fuses.
Special "Retrofit-Features".
